Current/Voltage Display - LORCH M 150 CuSi BasicPlus Manuel D'utilisation

Start-up
7-Segment display material thickness /
55
welding voltage
according to set characteristic line (see
chapter characteristic setting) or mode
either the material thickness, welding
voltage or secondary parameter codes
will be displayed.
Main switch
56
for switching the welding unit ON and
OFF.
Step switch material thickness / weld-
57
ing voltage
for adjusting the material thickness alt.
the welding voltage, values will be dis-
played in the 7.-segment display 55.
Symbol 230 V
58
lights up if 230 V welding voltage
is set. (machines with changeover
switch only).
Symbol 400 V
59
lights up if 400 V welding voltage is set.
Mode selection key
60
for setting of mode, either 2-stroke,
4-stroke, spot welding or interval.
Turning knob wire feed
61
for wire feed adjustment.
By activating the turning knob, the
wire feed is displayed in the 7-seg-
ment display 47 as correction value in
%, after setting in speed m/min.
10.13

13 .3 Current/voltage display

47
Current indicator
Voltage display
55
The actual values of welding voltage and
welding current are displayed during and
after welding. If any changes of the set val-
ues by the operator (i.e. step switch, turning
knob, key) take place, the main parameter
wire feed and material thickness will be dis-
played.
- 47 -