Characeristic Connection - LORCH M 150 CuSi BasicPlus Manuel D'utilisation

13 .4 Characeristic connection

Abb. 19: Characteristic table and selection knob
‰ The characteristic selection knob 65 and
the corresponding table are in the wire
feed casing.
The table content may differ from
i
your welding machine. The char-
acteristic lines are set individually
for each machine type.
 Select the required material-wire-gas
combination from the characteristic table.
 Read the corresponding characteristic
number off from the right hand column.
 Set the corresponding number from the
table using selection knob 65.
- 48 -
‰ Below the characteristic number 0 (man-
ual mode)
– is the material-wire-gas combination
nullified. Wire feed and welding volt-
age can be set manually.
– the welding step (Basic Plus) instead of
material thickness will be displayed.
– the must-value for welding voltage
(Control Pro) instead of material thick-
ness will be displayed.
If an unassigned number is set with
i
the characteristic selection knob
65, the 7-segment-display 47 will
display the error message „noP".
Start-up
65
10.13