Economical Best Practice; Overview Of Controls - Mitsubishi Electric Ecodan Cylinder unit EHST Série Mode D'emploi

2
Introduction

Economical Best Practice

Air source heat pumps can provide both hot water (providing a suitable cylinder is
used) and space heating all year. The system is different to a conventional fossil
heating system.
Important points about heat pump systems
• Domestic hot water and legionella functions are only available on cylinder units
or hydroboxes plumbed to an appropriate storage cylinder.
• In normal operation simultaneous DHW and space heating is unadvisable.
However during periods of extremely low ambient temperature, the immersion
heater (if present) can be used for DHW whilst the heat pump continues to pro-
vide space heating. Please be aware that the immersion heater, used alone, is
be used as a back up in normal operation.
• The hot water produced by the heat pump is typically at a lower temperature
than a fossil fuel boiler.

Overview of Controls

Built into the cylinder unit and hydrobox is the Flow Temperature Controller3
(FTC3). This device controls the function of both the outdoor heat pump unit and
the indoor cylinder or hydrobox. The advanced technology means that by us-
ing an FTC3 controlled heat pump you can not only make savings compared to
traditional fossil fuel type heating systems but also compared to many other heat
pumps on the market.
As explained in the earlier section, 'How the Heat Pump Works,' heat pumps are
technology enables the room temperature to be kept at the desired level whilst
In room temp (Auto adaptation) mode the controller uses temperature sensors
is regularly updated and compared to previous data by the controller to predict
space heating circuit accordingly. By monitoring not only the outdoor ambient, but
the room and heating circuit water temperatures, the heating is more consistent
and sudden spikes in required heat output are reduced. This results in a lower
Implications
• If the heat pump is being used for DHW the time at which tank heat up oc-
curs should be scheduled using the SCHEDULE function (see page 10).
Ideally this should be during the night time when little space heating is re-
quired and economy electricity tariffs can be taken advantage of.
• In most situations space heating is best performed using the room tempera-
ture mode. This enables the heat pump to analyse current room tempera-
ture and react to changes in a controlled manner utilising the specialised
Mitsubishi Electric controls.
• Using the SCHEDULE and HOLIDAY functions prevent unnecessary Space
or DHW heating when the property is known to be unoccupied for instance
during the working day.
•
costs of the system as the heat pump does not have to produce water at
4