Description Of Device; Start-Up; Operation - Beurer FB 12 Mode D'emploi

5. Description of device

1
3
7
6
5

6. Start-up

• Remove the packaging
• Check the device, power supply and cables for damage.
• Before you plug in the foot bath, fill it up to the fill-level mark (approx. 4 cm full) with either warm or
cold water. The foot rest should, however, be completely covered with water.
• Route the cable safely so that there is no risk of anyone tripping over it.
• Place the foot bath on a firm and level surface.

7. Operation

Make yourself comfortable in a chair and place your feet on the foot rest and apply slight pressure.
Never stand up in the foot bath. The rubber feet on the base of the unit prevent it from sliding.
Switch on the device. To do this, press the function button [2].
The vibration massage, bubble massage and water temperature regulator are started simultaneously.
Massage attachment
The massage attachment in the middle provides a comfortable massage for your feet and stimulates
the circulation. This can be removed for cleaning purposes.
Note
• Massage of a specific point on the sole of the foot may influence the corresponding organ of
the body. However, we recommend studying relevant literature and asking your doctor before
using point reflex zone massage to achieve the desired effect.
• A heater is fitted underneath the feet support. Warm water can be kept warm for a longer
length of time by switching on the heater. The heater is not suitable for heating cold water. To
achieve optimum results, it is recommended that the massage lasts no longer than 40 minutes.
After use, empty the water using the foot bath's narrow draining outlet [8].
2
8
4
13
1. Splash protection
2. Function button
3. Fill-level mark
4. Bubble bar
5. Massage attachment
6. Rubber feet (on underside of device)
7. Foot rest with massage nodules
8. Draining outlet