Transportation, Storage And Disposal - Husqvarna LB 248S Manuel D'utilisation

3. Put the air filter back. Make sure that the air filter
fully seals against the air filter holder.
4. Put the air filter cover back.
Note: An air filter that is used for a long time cannot be
fully cleaned. Replace the air filter at regular intervals.
Always replace a damaged air filter.
To examine the spark plug
CAUTION: Always use the recommended
spark plug type. Incorrect spark plug type
can cause damage to the product.
• Examine the spark plug if the engine is low on
power, is not easy to start or does not operate
correctly at idle speed.
• To decrease the risk of unwanted material on the
spark plug electrodes, obey these instructions:
a) Make sure that the idle speed is correctly
adjusted.
b) Make sure that the fuel mixture is correct.
c) Make sure that the air filter is clean.
• If the spark plug is dirty, clean it and make sure that
the electrode gap is correct, refer to
on page 15 . (Fig. 37)
Transportation and storage
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel tank before you put the product in
storage for a long period of time. Discard the fuel at
an applicable disposal location
• Safely attach the product during transportation to
prevent damage and accidents.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Keep the product in a dry and frost free area.
Disposal
• Obey the local recycling requirements and applicable
regulations.
• Discard all chemicals, such as engine oil or
antifreeze, at a service center or at an applicable
disposal location.
• When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
• Discard the battery at a service center or discard it at
a disposal location for used batteries.
14
Technical data

Transportation, storage and disposal

• Replace the spark plug if it is necessary.
To examine the fuel system
• Examine the fuel tank cap and the seal for the fuel
tank cap to make sure that there are no damages.
• Examine the fuel hose to make sure that there are
no leaks. If the fuel hose is damaged, let a service
agent replace it.
To adjust the clutch wire
If the drive starts to feel slow, it is necessary to adjust
the clutch wire.
1. To increase the drive speed, turn the adjuster screw
counterclockwise.
Note: If the drive is engaged when you do not pull
the drive bail, it is necessary to extend the wire.
2. To extend the wire and decrease the drive speed,
turn the adjustment screw clockwise. (Fig. 38)
If the drive feels slow also after the adjustment, let an
approved service agent replace the drive belt.
135 - 006 -