Bosch PSM 160 A Instructions D'emploi page 8

Tool Specifications
Multi sander
Order number
Rated input power
No-load speed
No-load orbit frequency
Sanding plate size
(corner to corner)
Orbit diameter
Weight without cable,
approx.
Protection class
Please observe the order number of your machine.
The trade names of the individual machines may vary.
Noise/Vibration Information
Measured values determined according to
EN 50 144.
Typically the A-weighted sound pressure level of
the product is 76 dB (A).
The noise level when working can exceed
85 dB (A).
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s
Machine Elements
The numbering of the machine elements refers to
the representation of the machine on the graph-
ics page.
1 Dust box (micro filtersystem)
2 Sanding sheet*
3 Sanding plate
4 SDS slider
5 On/Off switch
6 Outlet piece
7 Extraction adapter*
8 Vacuum hose*
9 Latching lever
10 Filter element (micro filtersystem)
11 Detail-sanding attachment*
12 Sanding sheet for attachment tongue *
13 Velcro backing for sanding tongue *
14 Sanding tongue (flat)*
15 Sanding tongue (oval)*
* Not all of the accessories illustrated or described are
included as standard delivery.
8 • 2 609 000 064 • 04.07
PSM 160 A
3 603 C77 0..
[W] 160
[rpm] 12 000
[opm] 24 000
[mm] 93
[mm] 1.6
[kg] 1.4
/ II
English - 1
Intended Use
The machine is intended for dry sanding and pol-
ishing of wood, filler and coated surfaces. It is es-
pecially suitable for profiles, corners or hard to
reach locations.
For Your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety notes in the enclosed booklet
must be observed.
Wear safety goggles.
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Do not op-
erate the machine in rain or moisture.
2
.
Always direct the cable to the rear away from
the machine.
The machine can be used only for dry sanding.
Do not work with materials containing asbes-
tos.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Always switch the machine off and wait until it
has come to a standstill before placing it down.
Never allow children to use the machine.
Bosch is only able to ensure perfect operation
of the machine if the original accessories in-
tended for it are used.