Other Operations - Sony MHC-S90D Mode D'emploi

Playing a disc (continued)

Other operations

To
Stop playback
Pause playback
Select a track or
chapter
Find a point in
a track title or
chapter
(Lock
Search function)
Change the
*2
playback speed
(Slow-motion play)
Playing the disc
frame by frame
changing the
playback speed *2
(Freeze Frame)
Select a disc when
playback is stopped
Switch to DVD
function from
another source
Remove the disc
GB
26
Do this
Press x (DVD/VIDEO CD/
CD). The playback stops at the
point x is pressed (Resume
Play). Press x again to cancel
the Resume Play (see page 30).
*1
Press X .
Press again to resume playback.
During playback or pause, press
> (or NEXT) (DVD/VIDEO
CD/CD) to go forward or .
(or PREV) (DVD/VIDEO CD/
CD) to go backward.
Press M or m (DVD/VIDEO
CD/CD) during playback. Each
time you press the button, the
speed changes as follows:
1 (slow) y 2 (faster than 1)
Press N SELECT to stop
searching at the desired point.
During playback, press SLOW
*3
t or T on the remote. Each
time you press the button, the
speed switches between two
slowed playback speeds. To
return to normal playback, press
N SELECT.
During playback, press STEP
c or C *3
on the remote.
Each time you press the button,
playback is advanced a single
frame in the desired direction.
To return to normal playback,
press N SELECT.
Press one of the DISC 1–3
buttons (or D.SKIP on the
remote).
Press one of the DISC 1–3
buttons (Automatic Source
Selection).
Press one of the DISC 1–3 Z
buttons.
*1
There may be some disturbance in the video
image.
*2
DVD and VIDEO CD only.
*3 SLOW t and STEP c are not available during
playback of VIDEO CDs.
Notes
• Depending on the DVD or VIDEO CD, some
operations may be prohibited.
• VIDEO CDs cannot be viewed slowly or frame by
frame in the reverse direction.
• Under the following circumstances, the sound field
is automatically set to "2CH STEREO".
– When recording.
– When TAPE B is in REC PAUSE mode.
– When recording using TAPE B.
• When using headphones, the sound from
headphones is 2 channel.
• Switch the sound field to "2CH STEREO" when
making an analog recording using a component
connected to the MD OUT jacks on this unit. There
is no audio output from the MD OUT jacks in the
multi channel mode.
• Depending on the DVD, digital recording may not
be done. In this case, perform analog recording.
Turn FILE SELECT to select "2CH STEREO"
when making an analog recording.
• Set the sound to "STEREO" using the AUDIO
button when you play DTS sound tracks on a CD
(page 34).
MHC-S90D 4-235-983-43(2) GB