Wilo Stratos PICO Série Notice De Montage Et De Mise En Service page 21

8.5 Activation of the Dynamic Adapt function
Press and turn the button to select the symbol for the Dynamic
Adapt function. Press and turn again to activate or deactivate
Dynamic Adapt.
The word "auto" indicates that Dynamic Adapt is activated.
If the word "auto" is not lit up, the function is deactivated.
Confirm setting by pressing the button.
Note: If the control mode Δp-c is active while Dynamic Adapt is
activated, the control mode automatically switches to Δp-v.
This is indicated by the Δp-v symbol flashing give times.
Factory setting: Dynamic Adapt OFF
8.6 Activation of the setback operation
Press and turn the button to select the symbol for the setback
operation. Press and turn it again to activate (ON) or deactivate
(OFF) the setback operation.
Confirm setting by pressing the button.
Factory setting: Setback operation OFF
8.7 Key lock (hold function)
Select the symbol for venting; this allows activation of the key
lock by pressing and turning the button. Hold the button down
for 10 seconds. The message "Hold" appears on the display. By
turning, the key lock can now be activated (ON) or deactivated
(OFF).
If the key lock is activated, the pump settings cannot be
changed. After 10 seconds the display shows power consump-
tion and the power consumption meter again. If the button is
pressed, "Hold" appears on the display.
To deactivate the key lock, repeat the steps as for activation.
Factory setting: Key lock OFF
Installation and operating instructions Wilo-Stratos PICO
English
17