Cleaning And Maintenance - Bestron A2010E Mode D'emploi

Cleaning and maintenance

Cleaning
1. Clean the outer surface of all parts with a damp cloth and a cleaner suitable for plastics. Make sure
no moisture gets into the appliance.
2. Over the course of time dust and dirt can accumulate around the wheel axles, thereby preventing
the wheels from turning easily. Consequently they should be kept clean.
PLEASE NOTE
• Never immerse the appliance, plug or power cord in water.
• Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes)
to clean the appliance.
Changing the dust bag
Change the dust bag immediately once the 'dust bag full' indicator turns red, see Figure 11.
PLEASE NOTE
It is possible that the indicator turns red whilst the dust bag is not yet full. If so, then the nozzle, hose or
tubes may be blocked. These will then need to be unblocked.
1. Open the cover by pulling
the cover release (dust bag)
upwards. Remove the dust bag
holder from the vacuum cleaner.
Remove the dust bag from the
holder, and dispose of it in a
dustbin.
2. Fit a new dust bag in the
holder with the arrow pointing
downwards, and press into
position. Place the dust bag
holder back.
3. Press the cover until it clicks into
place.
PLEASE NOTE
• Make sure that the dust bag
does not become pinched by the
cover. This could damage the
appliance and/or the dust bag.
Figure 11 Changing the dust bag
Note Dust bags for this vacuum cleaner are available from every major hardware store, with a
statement of the type number Bestron D00013/D0013S.
Cleaning or replacing the motor safety filter
Clean or replace the motor safety filter at least twice a year, and
more frequently if the filter is visibly blocked.
1. Remove the plug from the wall socket.
2. Remove the hose from the vacuum cleaner.
3. Open the cover by pulling the cover release (dust bag)
upwards.
4. Remove the dust bag, see Figure 11.
5. Remove the motor safety filter from the vacuum cleaner, see
Figure 12.
6. Dispose of the filter, or wash it in lukewarm water. Allow it to dry
thoroughly.
7. Return the cleaned or new filter to its holder, and return the
holder to the vacuum cleaner.
8. Fit the dust receptacle back into the holder. Press the cover
until it clicks into place.
Figure 12 Removing the motor safety filter
32
User's instructions