Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
user's instructions
7. Press the button on the telescopic tubes and keep it pressed in; you
can then extend or retract the tubes to the required length. See Figure 3b.
8. Press the foot button on the nozzle to set the combi nozzle for use on
hard or soft surfaces, see Figure 3c. For use on hard surfaces, press the
foot button on the combi nozzle to extend the brushes. Lift the button for
use on soft surfaces.
note
For wooden flors we reccomend you to use the special hard
floor brush
Accessories
This vacuum cleaner is supplied with 2 accessories (16):
•
a combined accessory
-
with a crevice tool with a narrow nozzle, which you can use to
clean radiators, window frames, crevices, small openings,
and similar;
-
with a dusting brush, which you can use to clean delicate or
irregular surfaces, furniture, Venetian blinds, and similar.
•
a furniture nozzle
operAtion - storage after use
1. Remove the plug from the wall socket.
2. Press the rewind button (13) and keep it pressed in; the
power cord will automatically rewind onto the reel.
Guide the power cord whilst it rewinds onto the reel,
since otherwise the cord could become tangled or the
plug could strike the back of the appliance. Take hold
of the power cord near the mark, and allow it to gently
slide through your fingers back into the appliance, see
Figure 5.
3. Stand the vacuum cleaner upright. Retract the telescopic tube completely. An attachment slot for
the telescopic tube is fitted to the bottom of the vacuum cleaner, next to the front castor (12)
(see Figure 6). Slide the bottom of the accessory bracket into the slot.
An attachment slot for the combi nozzle is fitted to
the back of the vacuum cleaner. Slide the bottom of
the combi nozzle into the slot
This avoids the need to dismantle the vacuum
cleaner after use; you can store the assembled
appliance and retrieve it again quickly when you
need it.
cleAninG And MAintenAnce
1. Clean the outer surface of all parts with a damp cloth and a cleaner suitable for plastics. Make sure no
moisture gets into the appliance.
2. Over the course of time dust and dirt can accumulate around the wheel axles, thereby preventing the
wheels from turning easily. Consequently they should be kept clean.
•
Never immerse the appliance, plug or power cord in water.
•
Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes)
to clean the appliance.
cleAninG And MAintenAnce - changing the dust bag
1. Change the dust bag immediately once the 'dust bag full' indicator (15) turns red, see Figure 7.
It is possible that the indicator turns red whilst the dust bag is not yet full. If so, then the nozzle, hose or
tubes may be blocked. These will then need to be cleaned.
Figure 4
23
a
b
c
Figure 3
Figure 5
Figure 6
Publicité
Table des Matières
