Bestron A2010E Mode D'emploi page 29

User's instructions
Use
1. Fit the hose connector in the opening on the
motor housing, see Figure 2. To remove the hose,
press on the two release buttons on the side of
the connector and pull the connector from the
opening.
Figure 2 Fitting the hose to the vacuum cleaner
2. Fit the telescopic tube into the hose
grip. (see Figure 3a)
3. Fit the combi nozzle or one of the other
accessories to the end of the telescopic
tube. You can also fit the combi nozzle
or one of the other accessories directly
to the hose grip. (see Figure 3b)
4. You can adjust the length of the
telescopic tube as follows (see Figure
3c):
a. push the slide button on the
telescopic tube downwards (in
the direction of the arrow on the
button).
b. Keep the slide button pressed
downwards, and slide the upper
section of the tube into or out of the
upper section.
c. Release the slide button.
Figure 3 Fitting the parts together
5. Press the foot button on the nozzle to set the combi
nozzle for use on hard or soft surfaces, see Figure 4. For
use on hard surfaces, press the rear of the foot button on
the combi nozzle to extend the brushes. Press the front of
the foot button for use on soft surfaces.
Figure 4 Soft or hard surfaces
3a 3b
29
3c