Connecting A Vacuum Cleaner - Makita LS003G Manuel D'instruction

Masquer les pouces Voir aussi pour LS003G:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2.
Install the outer flange and hex socket bolt, and
then use the hex wrench to tighten the hex socket bolt
counterclockwise securely while pressing the shaft lock.
1
2
3
► 1. Hex socket bolt (left-handed) 2. Outer flange
3. Circular saw blade 4. Ring 5. Inner flange
6. Spindle 7. Recessed side
3.
Return the blade guard and center cover to its
original position. Then tighten the hex bolt clockwise to
secure the center cover.
4.
Pull and turn the stopper pin in an unlocked posi-
tion to release the carriage from the raised position.
Lower the carriage and check that the blade guard
moves properly.
CAUTION:
Make sure shaft lock has released
spindle before making cut.

Connecting a vacuum cleaner

When you wish to perform clean cutting operation, con-
nect a Makita vacuum cleaner to the dust nozzle (upper
dust port) using a front cuff 24 (optional accessory).
► 1. Front cuff 24 2. Hose 3. Vacuum cleaner
4
5
7
1
2
3
Dust bag
CAUTION:
attach the dust bag or connect a vacuum cleaner
to prevent dust-related hazards.
6
The use of the dust bag makes cutting operations clean
and dust collection easy. To attach the dust bag, remove
the dust extraction hose from the tool and connect the
dust bag to the dust nozzle (upper dust port).
► 1. Dust extraction hose 2. Dust bag 3. Dust nozzle
(upper dust port)
When the dust bag is about half full, remove the dust
bag from the tool and pull the fastener out. Empty
the dust bag of its contents, tapping it lightly so as to
remove particles adhering to the insides which might
hamper further collection.
1
► 1. Fastener
22 ENGLISH
When performing a cutting, always
3
1
2

Publicité

Table des Matières
loading

Table des Matières