Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2
3
4
5
1
► 1. Hole 2. Over 15 mm (9/16") 3. Over 270 mm (10-
5/8") 4. 90 mm (3-1/2") 5. 145 mm (5-3/4") 6. 19 mm
(3/4") 7. 115 - 120 mm (4-1/2" - 4-3/4")
EXAMPLE When cutting workpieces 115 mm (4-1/2")
and 120 mm (4-3/4") high, use a wood facing with the
following thickness.
Miter angle
115 mm (4-1/2")
0°
20 mm (13/16")
Left and Right 45°
15 mm (9/16")
Left and Right 60°
15 mm (9/16")
Carrying tool
Before carrying the tool, be sure to remove the battery
cartridge and all movable parts of the miter saw are
secured. Always check the following:
•
The battery cartridge is removed.
•
The carriage is at 0° bevel angle position and
secured.
•
The carriage is lowered and locked.
•
The carriage is fully slid to the guide fences and
locked.
•
The turn base is at the full right miter angle posi-
tion and secured.
•
The sub bases are stored and secured.
Carry the tool by holding both sides of the tool base.
3
6
5
4
1
Thickness of wood facing
120 mm (4-3/4")
38 mm (1-1/2")
25 mm (1")
25 mm (1")
WARNING:
is for carrying and storage purposes only and not
for any cutting operations. The use of the stopper
pin for cutting operations may cause unexpected
movement of the circular saw blade resulting in kick-
back and serious personal injury.
7
CAUTION:
before carrying the tool. If portions of the tool move
or slide while being carried, loss of control or balance
may occur and result in personal injury.
CAUTION:
is properly locked at its bottom by the stopper
pin. If the stopper pin is not engaged properly, the
carriage may jump up suddenly and cause personal
injury.
WIRELESS ACTIVATION
FUNCTION
What you can do with the wireless
activation function
The wireless activation function enables clean and com-
fortable operation. By connecting a supported vacuum
cleaner to the tool, you can run the vacuum cleaner
automatically along with the switch operation of the tool.
To use the wireless activation function, prepare follow-
ing items:
•
A wireless unit (optional accessory)
•
A vacuum cleaner which supports the wireless
activation function
The overview of the wireless activation function
setting is as follows. Refer to each section for detail
procedures.
1.
Installing the wireless unit
2.
Tool registration for the vacuum cleaner
3.
Starting the wireless activation function
35 ENGLISH
Stopper pin for carriage elevation
Always secure all moving portions
Be sure that the carriage elevation
Publicité
Table des Matières
