Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
17. Do not remove the wireless unit from the slot
while the power is being supplied to the tool.
Doing so may cause a malfunction of the wireless
unit.
18. Do not remove the sticker on the wireless unit.
19. Do not put any sticker on the wireless unit.
20. Do not leave the wireless unit in a place where
static electricity or electrical noise could be
generated.
21. Do not leave the wireless unit in a place sub-
ject to high heat, such as a car sitting in the
sun.
22. Do not leave the wireless unit in a dusty or
powdery place or in a place corrosive gas
could be generated.
23. Sudden change of the temperature may bedew
the wireless unit. Do not use the wireless unit
until the dew is completely dried.
PARTS DESCRIPTION
1
2
28
27
26
25
24
1
Knob (for bevel angle)
5
Stopper arm
9
Hole for padlock
13
Vacuum button
17
Lock lever (for turn base)
21
Miter angle scale
25
Releasing button (for
right side bevel angle)
3
4
5
1
23
22
2
Hex wrench
6
Lock-off button
10
Wireless activation
button
14
Blade case
18
Releasing lever (for turn
base)
22
Pointer (for miter angle)
26
Vertical vise
24. When cleaning the wireless unit, gently wipe
with a dry soft cloth. Do not use benzine, thin-
ner, conductive grease or the like.
25. When storing the wireless unit, keep it in the
supplied case or a static-free container.
26. Do not insert any devices other than Makita
wireless unit into the slot on the tool.
27. Do not use the tool with the lid of the slot dam-
aged. Water, dust, and dirt come into the slot may
cause malfunction.
28. Do not pull and/or twist the lid of the slot more
than necessary. Restore the lid if it comes off
from the tool.
29. Replace the lid of the slot if it is lost or
damaged.
SAVE THESE INSTRUCTIONS.
8
7
14
15
16
18
20
21
3
Adjusting screw (for
lower limit position)
7
Switch trigger
11
Wireless activation lamp
15
Blade guard
19
Grip (for turn base)
23
Turn base
27
Stopper pin (for carriage
sliding)
8 ENGLISH
12
6
9
17
19
4
Adjusting bolt (for maxi-
mum cutting capacity)
8
Lid (for wireless unit)
12
Lamp button
16
Sub fence
20
Kerf board
24
Sub base
28
Slide pole
10
11
13
Publicité
Table des Matières
