Connecting A Vacuum Cleaner - Makita LS1440 Manuel D'instruction

► 1. Shaft lock
► 1. Socket wrench
To install the blade, mount it carefully onto the spindle,
making sure that the direction of the arrow on the sur-
face of the blade matches the direction of the arrow on
the blade case. Install the outer flange and hex bolt,
and then use the socket wrench to tighten the hex bolt
(left-handed) securely counterclockwise while pressing
the shaft lock.
25.4 mm
2
1
6
► 1. Spindle 2. Inner flange 3. Blade 4. Outer flange
5. Hex bolt 6. 25.4 mm marking
1
3
5
25 mm
1
► 1. Blade case 2. Arrow 3. Saw blade 4. Arrow
CAUTION:
• The inner flange has a 25 mm (63/64") diameter on
one side and a 25.4 mm (1") diameter on the other.
The side with 25.4 mm (1") diameter is marked by
"25.4". Use the correct side for the hole diameter of
the blade you intend to use. Mounting the blade on
the wrong side can result in dangerous vibration.
Slip the pin on the blade guard into the slot in the guide arm while
returning the blade guard to its original fully closed position. Then
tighten the hex bolt clockwise to secure the center cover. Lower
the handle to make sure that the blade guard moves properly.
Make sure shaft lock has released spindle before making cut.
4
► 1. Pin 2. Guide arm

Connecting a vacuum cleaner

When you wish to perform clean cutting operation,
connect a Makita vacuum cleaner.
9 ENGLISH
2
1
1
2
4 3