Denon DJ SM50 Guide D'utilisation page 2

User Guide (English)
Box Contents
SM50 Studio Monitor (1)
IEC Power Cable (1)
Isolation Pad (1)
Support
For complete system requirements, compatibility information, and product registration, visit the
Denon DJ website: denondj.com.
For additional product support, visit denondj.com/support.
Specifications
Frequency response
Crossover frequency
Low-frequency amplifier power
High-frequency amplifier power
LF cutoff
MF boost
HF trim
Acoustic space
Maximum signal-to-noise
(dynamic range)
Polarity
Input impedance
Input sensitivity
Power
Protection
Cabinet
Size (width x height x depth)
Weight (monitor + power cable)
2
User Guide
Safety & Warranty Manual
50 Hz – 20 kHz (+3 dB)
2.6 kHz
50 W with 20-gauge wiring to this transducer
40 W with 20-gauge wiring to this transducer
flat, 80 Hz, 100 Hz
In/Out of 2 dB centered at 2 kHz
+2 dB, 0 dB, -2 dB above 3 kHz
0 dB, -2 dB, and -4 dB
> 97 dB (typical A-weighted)
Positive signal at + input produces outward LF cone displacement
20 kΩ balanced, 10 kΩ unbalanced
100 mV pink noise input produces 92 dBA output SPL at 1 meter with
volume control at maximum
factory-programmed for either 115V ~50/60 Hz or 230V ~50/60 Hz
RF interference, output current limiting; over-temperature; transient
on/off protection to prevent speaker "pops"; subsonic filter; external
mains fuse
Front and rear baffle 1" MDF with 0.75" MDF wrap. Black lacquer
paint on enclosure with soft touch black paint on curved front plate.
8" x 12.5" x 10.1"
191 mm x 318 mm x 257 mm
17.2 lbs./unit
7.8 kg/unit
Above specifications subject to change without notice.