Playback - Teac UD-H01 Mode D'emploi

Playback

Press the POWER button to turn the unit power
1
ON.
If a power amplifier is connected, turn on the power
<
amplifier last .
2 Press the SOURCE button repeatedly to select a
source.
Each time the SOURCE button is pressed, the source
changes as follows:
USB (USB input for computers)
COAXIAL (Coaxial digital input)
OPTICAL (Optical digital input)
The input indicator of the selected source and the
indicator of the input sampling frequency light up .
The input indicator blinks when the input signal is not
<
digital audio data or the format of the audio signal is
not compatible with this unit, such as Dolby Digital,
dts, or AAC . If this happens, set the digital OUT setting
of the connected device to PCM audio output .
The frequency indicator blinks when there is no input
<
signal or the input signal cannot be locked .
If the sampling frequency of the input signal is 32 kHz,
<
the frequency indicators do not light up, but the input
indicators do .
To select "USB" to play back music files stored on a
<
computer, install dedicated TEAC driver software on
the computer before connecting the unit . (page 10)
Start playback on the connected source device,
3
and adjust the volume on the audio player.
9