Identifying The Parts - Teac UD-H01 Mode D'emploi

Identifying the Parts

A
A POWER
Press this button to turn the unit on and off . The blue indicator lights when the unit is turned on .
B SOURCE
Each time this button is pressed, the source changes .
C Input indicators
The source being selected lights up .
Blinks when the input signal is not digital audio data or the format of the audio signal is not
compatible with this unit, such as Dolby Digital, dts, or AAC .
D Frequency indicators
The sampling frequency of the signal being input lights up .
These indicators will blink when there is no input signal or the input signal cannot be locked .
* If the sampling frequency of the input signal is 32 kHz, the frequency indicators do not light
up, but the input indicators do .
E
PHONES
F PHONES LEVEL
Insert the headphone plug (stereo standard) into the headphone terminal (PHONES), and
gradually adjust the volume with the volume control (PHONES LEVEL) .
Be sure to set the volume to the minimum level before putting on the headphones . Do
not turn on/off the power or plug/unplug the headphones while wearing them . Doing
so may cause a loud sound to be suddenly emitted and cause hearing loss .
8
B C D E F