Specifications; Accessories - Teac UD-H01 Mode D'emploi

Specifications

Analog audio output
Jacks . . . . . . . . . . . . . . .XLR jacks (2 channel) x 1
Output impedance . . . . . . . . . . . . . . XLR: 100 Ω
Maximum output level (1 kHz, full scale,
10 kΩ)
Frequency response . . 5 Hz to 55 kHz (–3 dB)
Sampling frequency: 192 kHz
Signal-to-noise ratio (S/N) . . . . . . . . . . . .115 dB
Total harmonic distortion . . . .0 . 0 015% (1 kHz)
Sampling frequency: 192 kHz
Digital audio input
RCA terminal x 1 (input impedance 75 Ω)
Optical digital terminal x 1
USB port – B connector . . . . . . . . . . . . . .USB 2 . 0
Data sampling frequency
32*/44 . 1 /48/88 .2/96/176 . 4 /192 kHz
* If the sampling frequency of the input
signal is 32 kHz, the frequency indicators
do not light up, but the input indicators
do .
Data bit length . . . . . . . . . . . . . . . . . . . 16/24 bits
14
RCA jacks (2 channel) x 1
RCA: 47 Ω
XLR (Gain: 0 dB): 2 . 0 Vrms
RCA: 2 . 0 Vrms
0 . 5 Vp-p
–24 . 0 to –14 . 5 dBm peak
General
Power supply
Europe model . . . . . . . . . . . . 230V AC, 50 Hz
U . S .A ./Canada model . . . . . 120V AC, 60 Hz
Power consumption . . . . . . . . . . . . . . . . . . . 13 W
External dimensions (W x H x D)
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 . 5 kg
Operating temperature . . . . . . +5 °C to +35 °C
Operating humidity
5 % to 85 % (no condensation)
Storage temperature . . . . . . . –20 °C to +55 °C

Accessories

Power cord x 1
RCA audio cable x 1
Owner's manual (this document) x 1
Warranty card x 1
Design and specifications are subject to change
<
without notice .
Illustrations may differ slightly from production
<
models .
The nameplate is located on the bottom of the
unit as shown below .
215 x 61 x 231 mm
(including protrusions)
Nameplate