Clean Operating Screen And Housing; What To Do If - Electrolux EDE1074PDW Notice D'utilisation

12 electrolux
1.
Open loading door and remove laun-
dry.
2. Remove the filter which is built into the
lower part of the loading aperture.
3.
Open the filter pressing the button,
among two slots on fingers. Clean the
filter using dump hand or cloth. After a
period of time, a patina due to deter-
gent residue on laundry forms on the fil-
ters. When this occurs, clean the filter
with warm water using a brush.
Close the filter and do not forget to put
it back.
Warning! Before You place the filter,
please check it there is nothing inside
the filter seat.

WHAT TO DO IF ...

TROUBLESHOOTING BY YOURSELF
If, during operation, the error code E... plus
number or letter) appears on the LCD:
Switch the machine off and on again. Reset
Problem
4. The filter can be positioned only to one
side. If position is wrong, the filter over-
hangs.
If the filter will not snap into place, the
loading door cannot be closed.
CLEANING THE DOOR
Clean periodically the interior part of the
door to remove any fluff. Accurate cleaning
ensures correct drying.
CLEANING THE DRUM
Caution! Do not use abrasives or steel
wool to clean the drum.
Lime in the water or cleaning agents
may form a barely visible lining on the
inside of the drum. The degree to
which the laundry has been dried is
then no longer detected reliably. The
laundry is damper than expected when
removed from the dryer.
Use a standard domestic cleaner (e.g.
vinegar-based cleaner) to wipe down
the inside of the drum and drum ribs.
CLEAN OPERATING SCREEN AND
HOUSING
Caution! Do not use furniture cleaners
or aggressive cleaning agents to clean
the machine.
Use a damp cloth to wipe down the
operating screen and housing.
programme. Press the START/PAUZE
(START / PAUSE) button If the error is still
displayed, please inform your local Service
Force Centre and quote the error code.
Possible cause Remedy