Clean Operating Screen And Housing; What To Do If; Troubleshooting By Yourself - Electrolux TK SL 3E Notice D'utilisation

Use the handle to pull the heat exchang-
er out of the base and carry it horizontal-
ly to prevent any remaining water from
spilling.
6. To empty the heat exchanger, hold verti-
cally over a washing-up bowl.
Caution! Do not use sharp objects to
clean. The heat exchanger could
develop leaks.
7. Clean heat exchanger.
It is best to use a brush or to rinse thor-
oughly with a hand-held shower.
8. Replace heat exchanger and lock into
place (turn both lock washers outwards
until they snap into place).
9. Close door in plinth.
Caution! Never operate the dryer
without the heat exchanger.

WHAT TO DO IF ...

Troubleshooting by yourself

1)
Problem
Dryer not connected to mains supply.
Dryer does
not work. Loading door opened.
The START PAUSE button not pressed.
Incorrect programme set.
Fluff filters clogged.
Heat exchanger clogged.
Unsatisfactory
Max. loading exceeded.
drying results.
Covered ventilation grill.
Residue inside the drum.
High water hardness.
Loading door
Filters not locked in place.
does not close
Err ( Error )
Attempt to change parameters after
5)
start of the programme.
on the LCD.
Programme selector in OFF position.
No drum light
Defective light bulb.
Abnormally
Time to end is calculated on the basis
elapsing time
of: type, volume and dampness of laun-
5)
dry.
on the LCD
Programme
Full water reservoir.
inactive
All manuals and user guides at all-guides.com
To clean the drum

Clean operating screen and housing

Possible cause
Caution! Do not use abrasive materials
to clean the drum. Use a soft detergent
to clean the inner side of the drum and
the drum blades.
Keep the inner surface of the drum and
the drum blades clean. The minerals
from the water or cleaning agents can
collect on the inner surface of the
drum. This cause that the laundry is not
sufficient dry.
Caution! Do not use furniture cleaners
or aggressive cleaning agents to clean
the appliance.
Use a damp cloth to wipe down the op-
erating screen and housing.
Remedy
Plug in at mains socket. Check fuse in
fuse box (domestic installation).
Close loading door
Press the START PAUSE button.
Set suitable programme.
3)
Clean fluff filters.
Clean heat exchanger.
Respect max. loading volume.
Uncover ventilation grill in base area.
Clean the drum inside.
Set suitable water hardness
Install fine filter and/or snap course filter
into place.
Turn the dryer off and on. Set requested
parameters.
Turn it to DRUM LIGHT (if available) or
to any programme.
Replace light bulb (see next section).
Automatic process; this is not a ma-
chine fault.
3)
Empty water reservoir
PAUSE button.
electrolux 83
2)
3)
4)
.
, press START