Electrolux TK SL 3E Notice D'utilisation page 79

buzzer
The appliance is supplied with the buzzer
function deactivated.
To activate buzzer choose buzzer option.
When the option is active, the buzzer
icon is on.
The buzzer sounds or plays a tune during:
– cycle end
– anti-crease phase and when phase starts
or ends
– cycle interruption by a warning
– alarm
TIME (Zeitwahl)
Operates only with TIME PROGRAMME
(Zeitprogramm) . Allows to set individual
time of drying from minimum 10 min. to max-
imum of 3 hours (in 10 min. steps).
1. Turn the programme knob to the TIME
PROGRAMME (Zeitprogramm) .
2. Press the TIME (Zeitwahl) button repeat-
edly until the desired programme dura-
tion is shown in the display, e.g.
for a programme of 1 hour and 20 mi-
nutes.
DELAY START (Zeitvorwahl)
Allows to delay the start of a drying pro-
gramme from minimum of 30 min. to
maximum of 20 hours.
1. Select the drying programme and addi-
tional options.
2. Press the DELAY START (Zeitvorwahl)
button repeatedly until the desired delay
start is shown in the display, e.g.
the programme has to start after 12
hours.
3. To activate the delay timer, press the
START PAUSE button. Time to start elap-
ses in the displayed.
Child lock
The child lock can be set to prevent a pro-
gramme being accidentally started or a pro-
gramme in operation being accidentally
changed. The child lock function locks all
buttons and the programme knob. The
child lock can be activated or deactivated
by holding down the OPTION and OK but-
tons simultaneously for 5 seconds.
– Before programme is started: Appli-
ance cannot be used
All manuals and user guides at all-guides.com
The
cate that the child safety device is activated.
The child safety device is not deactivated
once the programme comes to an end.
If you want to set a new programme, you
must first deactivate the child safety device.
Starting the programme
Press the START PAUSE button . The pro-
gramme is started.
The programme progress is shown in LCD
by appropriate set of icons. From left to the
right, from iron dry
icon depends on the drying cycle chosen.
E. g. in case of cupboard dry programme
the following status icons are visible:
marked by flashing dash under status icon.
When appropriate part of drying cycle is ac-
complished dash becomes steady and ap-
pears flashing under next status icon.
Changing programme
To change a programme which has been se-
lected by mistake once the programme has
started, first turn the programme selector to
OFF (Aus) and then reset the programme.
if
Programme complete / Laundry
unloading
Once the drying cycle is complete, display
shows a blinking
icon appears dash. If the buzzer option has
been set, an acoustic signal sounds intermit-
tently for about one minute.
– After programme is started: Pro-
gramme in operation cannot be
changed
icon appears in the display to indi-
to anti-crease
. Current cycle progress is
The programme can no longer be
changed directly once the programme
has started. If nevertheless there is an
attempt to change the programme on
the programme knob, the programme
progress display and the maintenance
indicators flash. If an option (excluding
the buzzer ) is set, Err appears in the
multidisplay. The drying programme is
not however affected by this (laundry
protection).
, under anti-crease
electrolux 79