Machine Settings; Hints For Test Institutes - Electrolux TK SL 3E Notice D'utilisation

The consumption values have been established under standard conditions. They may deviate when
Programme
COTTON CUPBOARD DRY
2)
COTTON IRON DRY
SYNTHETICS CUPBOARD DRY
1) Different loading volume data may be needed in some countries as a result of different measuring methods.
2) in accordance with EN 61121

MACHINE SETTINGS

Setting
Buzzer permanent
on/off
1)
Water hardness
Emptying water res-
ervoir - warning
2)
off
1) Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to
geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the water
compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the end of
the cycle. Your dryer allows you to regulate the sensitivity of the drying sensor based on conductivity values of the
water.
2) By default the warning LED is always on at the end of the drying cycle or during the cycle if the water reservoir is
full. When using an external drain for the condensed water warning can be offi

HINTS FOR TEST INSTITUTES

Parameters possible to check by the Test In-
stitutes:
All manuals and user guides at all-guides.com
Consumption values
the machine is operated in domestic circumstances.
2)
2)
1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS (Trockengrad) and SPIN SPEED (U/
Min.) buttons and hold down for approx. 5 seconds.
3. The buzzer is by default always off. You can use the buzzer option to
activate or deactivate sound but the machine does not memorise your
selection.
1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS (Trockengrad) and TIME (Zeitwahl)
buttons and hold down for approx. 5 seconds. The current setting is on
the display:
–
low conductivity <300 μS/cm
–
medium conductivity 300-600 μS/cm
–
high conductivity >600 μS/cm
3. Press the START PAUSE button sequentially until you set desired level.
4. To memorise setting press simultaneously the DRYNESS (Trockengrad)
and TIME (Zeitwahl) buttons or turn knob to OFF (Aus) position
1. Turn the programme selector to any programme.
2. Press simultaneously the SPIN SPEED (U/Min.) and TIME (Zeitwahl) but-
tons and hold down for approx. 5 seconds.
The current setting is on the display:
– warning
icon and
– warning
icon and
Energy consumption in kWh / average dry-
ing time in min.
4.48 / 135 (8 kg load pre-drained at 1000 rpm)
4.3 (8 kg load pre-drained at 1200 rpm)
4.0 (8 kg load pre-drained at 1400 rpm)
3.5 (8 kg load pre-drained at 1800 rpm)
3.8 / 108 (8 kg load pre-drained at 1000 rpm)
1.3 / 45 (3 kg load pre-drained at 1200 rpm)
Implementation
- warning message is off
- warning message is switched on
• Energy consumption (corrected with final
humidity) during the cupboard dry cotton
cycle with nominal load.
electrolux 85