Settings; Daily Use - Electrolux EDC2086PDW Notice D'utilisation

6. SETTINGS

A)
Tijd (Time)
B)
Startuitstel (Delay)
C)
Fijne was (Delicate)
D)
Wol Belading (Wool Load)
pad
E)
Start/Pauze (Start/Pause)
pad
6.1 Child lock function
This option prevents children to play with
the appliance while a programme oper-
ates. The programme knob and the
touchpads are locked. Only the on/off
button is unlocked.
Activating the child lock option
1. Press the on/off button to activate the
appliance.
2. Press and hold touchpads (A) and (D)
at the same time until the child lock in-
dicator comes on.
• It is possible to deactivate the child
lock option while a programme op-
erates. Press and hold the same
touchpads until the child lock indi-
cator goes off.

7. DAILY USE

Before you use the appliance for the
first time
1. Clean the appliance drum with a moist
cloth.
2. Start a short programme (e.g. 30 mi-
nutes) with moist laundry.
A
B
C
D
E
touchpad
touchpad
touchpad
touch-
touch-
6.2 Buzzer on/off
To deactivate or activate the acoustic sig-
nals, press and hold for approximately 2
seconds touchpads (B) and (C) at the
same time.
6.3 Water hardness and
conductivity
Water hardness is different for different lo-
cations. Water hardness has an effect on
the water conductivity and on the con-
ductivity sensor of the appliance. If you
know, the value of the water conductivity
you can adjust the sensor in order to have
better drying results.
Adjusting the conductivity sensor
1. Press the on/off button to activate the
appliance
2. Press and hold touchpads (A) and (B)
at the same time until one of the these
indicators comes on:
•
(low <300 μS/cm)
•
(moderate 300-600 μS/cm)
•
(high >600 μS/cm)
3. Press the touchpad (E) again and
again until the indicator of the correct
level comes on.
4. To confirm the adjustment, press and
hold touchpads (A) and (B) at the
same time for approximately 2 sec-
onds.
7.1 Starting a programme
without delay start
1. Prepare the laundry and load the ap-
pliance.
2. Press the on/off button to activate the
appliance.
3. Set the correct programme and op-
tions for the type of load.
ENGLISH 23