Technical Data - Electrolux EDC2086PDW Notice D'utilisation

28 www.electrolux.com
Problem
The appliance stops during opera-
tion.
The display shows a long pro-
gramme duration.
The display shows a short pro-
gramme duration.
The display shows Err.
The display shows E51)
1) After maximum 5 hours, the programme ends automatically
10.2 If the drying results are not
satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The condenser is clogged.

11. TECHNICAL DATA

Dimensions (mm)
Max. depth
(with the appliance door open)
Max. width
(with the appliance door open)
Electrical connection
Drum volume
1)
Width / Height / Depth
Voltage
Frequency
Fuse
Total power
Possible solution
Make sure that the water container is emp-
ty. Press Start/Pauze (Start/Pause) to start
the programme again.
Make sure that the weight of the laundry is
applicable to the duration of the pro-
gramme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in
the washing machine again.
Make sure that the room temperature is
not too warm.
Set the Tijd (Time Drying) or the Extra
Droog (Extra Dry) programme.
If you want to set a new programme, de-
activate and activate the appliance.
Make sure that the options are applicable
to the programme.
Deactivate and activate the appliance.
Start a new programme. If the problem oc-
curs again, contact the Service.
• There was too much laundry in the ap-
pliance.
• The drum is dirty.
• Incorrect setting of the conductivity
sensor.
• The airflow slots are clogged.
600 / 850 – 865 / 600
1090 mm
950 mm
230 V
50 Hz
16 A
2800 W
118 l