Electrolux TK SL 3E Notice D'utilisation page 70

70 electrolux
Important!
• The hot air emitted by the tumble dryer
can reach temperatures of up to 60°C.
The appliance must therefore not be in-
stalled on floors which are not resistant to
high temperatures.
• When operating the tumble dryer, the
room temperature must not be lower
than +5°C and higher than +35°C, as it
may affect the performance of the appli-
ance.
• Should the appliance be moved, it must
be transported vertically.
• The appliance must not be installed be-
hind the lockable door, a sliding door a
door with a hinge on the opposite side to
that of the appliance in such a way that a
full opening of the dryer is restricted.
Removing transport safety packaging
Caution!
Before use all parts of the transport packag-
ing must be removed.
1. Open loading door
2. Pull off adhesive strips from inside ma-
chine on top of drum.
3. Remove foil hose and polystyrene pad-
ding from the machine.
Electrical connection
Details on mains voltage, type of current
and the fuses required should be taken
from the type plate. The type plate is fitted
near the loading aperture (see "Product de-
scription" chapter).
Connect the machine to an earthed
socket, in accordance with current wir-
ing regulations.
Warning! The manufacturer
declines any responsibility for
damage or injury through failure to
All manuals and user guides at all-guides.com
Door reversal
1.
2. Unscrew hinge A from the front of the
3. Remove cover plates B . To do this, in-
4. Use an appropriate tool and exert pres-
5. Unscrew hinge A from the loading
6. Re-insert cover plates B on the oppo-
7.
8. Unscrew door lock E , push down slight-
comply with the above safety
precautions.
Should the appliance power supply
cable need to be replaced, this
must be carried out by our Service
Center.
Warning! The plug must be
accessible after installing the
machine.
Warning! Before changing the door
stop, disconnect the mains plug.
A
A
Open loading door.
machine and take off the loading door.
sert a thin screwdriver into the slots as
shown in the illustration, press down-
wards slightly and pry out the cover
plates.
sure to unfasten locking block C from
the snap-on fixture, take out and re-in-
sert on the other side having rotated
the block through 180°.
door, rotate through 180°, re-insert on
the opposite side and screw down.
site site having first rotated them
through 180°.
D
E
E
D
Unscrew cover plates D from the front
of the machine, rotate through 180°,
screw on the opposite side.
ly and remove from the front of the ma-
chine.
B
C
B
1
F F