Electrolux EDE1074PDW Notice D'utilisation page 13

Masquer les pouces Voir aussi pour EDE1074PDW:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Dryer does not work.
Drying results unsatisfactory.
Loading door does not close.
When a button is pressed, Err
appears on the LCD.
Drum light does not work.
Displayed programme time
changes erratically or stays un-
changed for a long time.
Drying cycle ends shortly after
programme starts.
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends au-
tomatically.
CHANGING THE BULB FOR INTERIOR
LIGHTING
Only use a special bulb which is designed
specially for dryers. The special bulb can be
obtained from your local Service Force cen-
tre.
Warning! When the appliance is
switched on, the interior lighting
Mains plug is not plugged in or
fuse is not working correctly.
Loading door is open.
Have you pressed the START/
PAUZE (START / PAUSE) but-
ton?
Wrong programme selected.
Filter clogged.
Overloading of laundry.
Ventilation slots covered up.
Residue on inside surface of
drum or drum ribs.
Conductance of water at instal-
lation site differs from standard
setting of machine.
Filter not in place.
Washing protection. After the
start of the programme, the op-
tion can no longer be set.
Programme selector in "O"
(OFF) position.
Defective light bulb.
Programme time is corrected
automatically depending on
type and volume of laundry and
level of dampness.
Not enough washing loaded or
washing loaded is too dry for
selected programme.
Filter clogged.
Load volume too big.
Laundry insufficiently spun.
Plug in at mains socket. Check
fuse in fuse box (domestic in-
stallation).
Close loading door.
Press the START/PAUZE
(START / PAUSE) button again.
Select a different programme
the next time you dry (see "Pro-
gramme chart" chapter).
Clean filter.
Observe recommended loading
volumes.
Uncover ventilation slots.
Clean inside surface of drum
and drum ribs.
Re-programme standard set-
ting for degree of drying (see
'Programming options' chap-
ter).
Install filter into place.
Turn the programme knob to
"O" (OFF) . Set the programme
again.
Turn programme selector to
any programme.
Replace light bulb (see next
section).
Automatic process; this is not a
machine fault.
Select time programme or
higher drying level (e.g. EXTRA
DROOG (EXTRA DRY) instead
of KASTDROOG (STORAGE
DRY) ).
Clean filter.
Reduce load volume.
Laundry must be adequately
spun.
switches itself off after 4 minutes when
the door is open.
Warning! Do not use standard bulbs!
These develop too much heat and may
damage the machine!
Warning! Before replacing the bulb,
disconnect the mains plug.
electrolux 13

Publicité

Table des Matières
loading

Table des Matières