Fitting The Vent Hose - Electrolux EDE1074PDW Notice D'utilisation

16 electrolux

FITTING THE VENT HOSE

To simplify the installation, there is a choice
of vent outlets: one at the back, the others
in the left and right-hand side. Connect the
hose to whichever is the more convenient
by pulling the ring nut (A) from the vent out-
let at the back, screwing it on to the hose
and pushing it firmly back into place. The
unused vents should now be sealed with
the special snap covers provided.
A
If the hose is long and the room tempera-
ture low, the moisture might condense to
water inside the hose. This is an unavoida-
ble natural phenomenon. To prevent this
water from Iying in the hose or flowing back
into the tumble dryer, it is advisable to drill a
small hole (via. 3 mm) in the lowest point of
the hose and to place a small container be-
low it. (See picture, point B).
Once connected to the dryer, run the vent
hose to the desired outlet point, ensuring
that the run's overall length is less than 2
m, and that it contains no more than two
bends. As to the outlet itself, if you have de-
cided on a fixed wall/window grille, a good
local builder's merchant should be able to
supply you with the necessary fittings and
installation advice.
A
B