Fracarro SIG9708CI Instructions D'emploi page 29

Programming the input transponder. Set the LNB, IF frequency, and choose the specific channel within the
selected transponder. Pre-memorized channels can also be programmed by selecting them from the presets
list. See Presets list on page 25.
INPUT
Set remote power
for LNB
Set the DiSEqC tone
Reading the frequency of
the local oscillator
IF frequency of the
transponder
to be received
Symbol rate of the
transponder
to be received
FEC of the transponder
to be received
List of available
programs
confirm the settings by
pressing the
the settings by pressing
the S key after the
modules programmation
Selezione di un canale
prememorizzato
PRESET OFF
LNB OFF
DiSEqC A
OL FREQ. (MHz)
IF FREQ. (MHz)
SYMBOL RATE
FEC AUTO
SERVICE LIST 1/N PROGRAM 1
SERVICE PROPR. PROGRAM NAME
TELETEXT PID
SUBHEADINGS
SERVICE TYPE
key; save
AUDIO TYPE IN
4.7 INPUT
PRESET 1
Enter with
LOAD PRESET
SAVE PRESET
18V/22KHz
satellite A
satellite B
satellite C
D
satellite D
Read-only
AUTO
950 2150
1000 45000
Read-only
N/N PROGRAM N
ID Service of the selected
SERVICE ID
program
PCR PID
VIDEO PID
AUDIO PID
Subheadings selection
Video Format of the
FORMAT
selected program
29
PRESET 10
Enter with
Loading ...
OFF
14V/0KHz
18V/0KHz
14V/22KHz
18V/22KHz
Increase/decrease by TPE arrows or enter the
value directly by the digit keyboard.
Increase/decrease by TPE arrows or enter the
value directly by the digit keyboard.
"Not available": transponder not
locked.
"NONE": ID service not present
Enter value by TPE
digit keyword
Increase/decrease with the
arrows of the TPE keyboard.
Increase/decrease with the
arrows of the TPE keyboard.