Fracarro SIG9708CI Instructions D'emploi page 27

4.5 HEADEND SETUP AND KTP EMULATION MENU
Navigation in the headend
HEADEND
SETUP
Setting OSD mode
Automatic
acknowledgement of the
headend connected to
the TPE
Export the headend
configuration to another
Restore the headend
default settings
Not available
Reset module
Emulation of the
KTP programmer
KTP
EMULATION
Confirm the settings by pressing the
programming menus
NAVIGATION
OSD NAVIGATION
HEADEND SCAN
COPY
FACTORY SETUP
SET ADDRESS
RESET MODULE
KTP Emulation
KTP
EMULATION
the modules programmation
XXX
SIG9708CI
XXX
SIG9708CI
Search Module....
Copy Paste
XXX
XXX
SIG9708CI
SIG9708CI
All
XXX
modules
SIG9708CI
Change address
XXX
SIG9708CI
All
XXX SIG9708CI
modules
V=OUTPUT
key; save the settings by pressing the S key after
27
Refer to the general
programming menu of the
SIG9708CI headend
On screen display
Automatic search of the headend or
connected device. After searching,
the main menu can be seen from
the NAVIGATION function.
YES=V NO=X
YES=V NO=X
Select the new
address by the up/
Current: xxx
down arrows. Confirm
New: xxx
by pressing the V key.
YES=V NO=X
This function is not available
for the programming of the
SIG9708CI headend