Fracarro SIG9808CI Instructions D'emploi page 32

Verification of the software version of the headend, BER and S/N measurements. BER and S/N are
approximate values.
MEASURES
Ber of the input signal
S/N of the input signal
Information for
OFDM modulation
parameters
Confirm the settings by pressing the
CAM settings and reset. The CAM menu depends on the specific module. In the "CAM CONTROL" menu,
all the messages that come from the CAM when it is operating can be displayed; moreover, you can interact
with the CAM with the TPE programmer.
COMMON INTERFACE
Confirm the settings by pressing the
4.8 MEASURES MENU
Module software version
SOFTWARE REL.
BER
S/N (dB)
OFDM PARAMETERS
Read-only
key; save the settings by pressing the S key
after the modules programmation.
4.9 COMMON INTERFACE MENU
CI MENU
CAM CONTROL
CAM RESET
after the modules programmation.
SIG9808 v.2
1,3*10E-4
11
MODULATION
HIERARCHY
CODE RATE
GUARD INTER.
MODE
Enter the OSD navigation
of theCAM
Reset hardware of
the CAM module
key; save the settings by pressing the S key
32
1= undetected signal
0= undetected signal
QPSK
Type of modulation
16-QAM
of the selected
64-QAM
multiplex
NONE
Selected multiplex
Alta
hierarchy type
bassa
1/2,2/3,
Display for c ode
3/4,5/6,
rate type
7/8
1/4, 1/8, Display for guard
1/16,1/32
interval
Display for
2K
carriers number
8K
"not available" i f the
CAM not insert
"not valid" if the CAM has
not messages to display