Digital Component Hookups - Sony TA-VE910 Mode D'emploi

Digital Component Hookups

Overview
This section describes how to connect an LD player,
DAT/MD deck, and CD player equipped with digital
jack(s) to the amplifier. If you use a digital component,
select the appropriate input mode for the component
(see page 11).
LD IN AC-3 RF/
OPTICAL CD IN OPTICAL
LD IN
TV LD VIDEO 2 VIDEO 1 MONITOR
AC-3 RF
IN OUT IN OUT
LD IN
OPTICAL
CD IN VIDEO VIDEO VIDEO VIDEO VIDEO VIDEO VIDEO
IN IN OUT IN OUT IN OUT
OPTICAL
DAT / MD IN
OPTICAL AUDIO AUDIO AUDIO AUDIO AUDIO AUDIO
SIGNAL
IN IN OUT IN OUT IN
GND
DAT / MD OUT
L
OPTICAL
y
R
LD IN
COAXIAL
IN IN IN RECOUT IN RECOUT IN A
L
DIGITAL R
R
B
PHONO TUNER CD DAT / MD TAPE
LD IN DAT/MD IN/OUT
COAXIAL OPTICAL
What cords will I need?
• Optical digital connecting cord (not supplied) (1 for an LD
or CD player; 2 for a DAT or MD deck)
• Coaxial digital connecting cord (not supplied) (1 for an LD
player)
Hookups
The arrow ç indicates signal flow.
LD player
Connect the LD player either to the LD IN COAXIAL or
OPTICAL jack.
LD player Amplifier
LD IN
DIGITAL
COAXIAL
AC-3 RF
OUT LD IN
OPTICAL
CD IN
OPTICAL
DAT / MD IN
OPTICAL
DAT / MD OUT
OPTICAL
LD IN
ç
COAXIAL
DIGITAL
SURROUND SPEAKERS
R REAR L CENTER
AC OUTLET
WIRELESS SWITCHED 100W MAX
REAR
+ +
SPEAKER
WOOFER
AUDIO – –
OUT
R L
IMPEDANCE USE 4–16 Ω
FRONT SPEAKERS
IMPEDANCE USE 4–16 Ω
+ – – +
A
L
+ – – +
B
LD player
DIGITAL
OPTICAL
OUT
Ç
If your LD player has an RF output jack, connect it to the LD
IN AC-3 RF jack of the amplifier as shown below.
Amplifier
LD IN
Ç
AC-3 RF
LD IN
OPTICAL
CD IN
OPTICAL
DAT / MD IN
OPTICAL
DAT / MD OUT
OPTICAL
LD IN
COAXIAL
DIGITAL
CD player
Amplifier
LD IN
AC-3 RF
LD IN
OPTICAL
CD IN
Ç
OPTICAL
DAT / MD IN
OPTICAL
DAT / MD OUT
OPTICAL
LD IN
COAXIAL
DIGITAL
DAT or MD deck
Amplifier
LD IN
AC-3 RF
LD IN
OPTICAL
CD IN
OPTICAL
DAT / MD IN
Ç
OPTICAL
DAT / MD OUT
X ç
OPTICAL
LD IN
COAXIAL
DIGITAL
Warning regarding the playback of DAT/MD sources
When playing DAT/MD sources through the amplifier,
do not play a DAT/MD that contains digital recordings
made from a DVD player whose digital output was set
to "DOLBY DIGITAL." High volume noise will be
output which may damage the amplifier and your
speakers.
Notes
• This amplifier is compatible only with digital components
using 32, 44.1, or 48-kHz sampling frequencies and not
compatible with 96 kHz.
• Be sure to connect digital components (CD player, DAT/
MD deck, etc.) to the analog jacks as well as the digital
jacks in order to do analog recording.
Getting Started
Getting Started
LD player
AC-3
RF
OUT
CD player
DIGITAL
OUT
DAT or MD deck
DIGITAL
OUT IN
EN
9