Sony TA-VE910 Mode D'emploi page 17

Adjusting the speaker volume Z
Use the remote while seated in your listening position
to adjust the volume of each speaker.
Note
This amplifier incorporates a new test tone with a frequency
centered at 800 Hz for easier speaker volume adjustment.
– +
SUB CH POSITION
0 )
GENRE
— RMS —
DIRECTION
9 (
— SOUND FIELD —
SOUND FIELD ON/OFF GENRE
EQ/
TONE BAND
ON/OFF
DIGTAL
DIRECT
PROCESSING
CONTROL
DIGITAL
DPC
MODE
PROCESSING
PROGRAMMABLE
CONTROL
1
Press SOUND FIELD ON/OFF to turn on the
sound field.
2
Press GENRE repeatedly to select "DOLBY."
3
Press MODE to select "NORMAL SURROUND"
or "ENHANCED SURROUND."
4
Press TEST TONE.
You will hear the test tone from each speaker in
sequence.
5
From your listening position, use the digital
processing control buttons (
parameter to be set and use the buttons (
to select the setting so that the test tone can be
heard at the same level from all speakers.
To adjust Select
rear speaker REAR L R
balance
rear speaker REAR
level
center speaker CENTER
level
subwoofer SUB WOOFER –20.0dB and +10.0dB
level
During adjustment of the respective speaker level/
balance, the test tone is output from the speaker(s)
only.
After adjusting the subwoofer level, the test tone
turns off automatically.
ANT
SWAP TV/VTR
= +
D. SKIP
MODE
CLEAR P IN P JUMP
p P r
TEST
MODE TONE
TEST TONE
SLOPE — LEVEL —
+ +
CENTER
REAR CENTER
– –
LEVEL +/–
MASTER
BASS
VOL
BOOST
MUTING
REAR
LEVEL +/–
/ ) to select the
/ )
And set between
L (left) and R (right)
–20.0dB and +10.0dB
(in 0.5 dB steps)
–20.0dB and +10.0dB
(in 0.5 dB steps)
(in 0.5 dB steps)
Dolby Surround Setup
To turn off the test tone
Press TEST TONE.
z
You can use other buttons to adjust the center and
rear speaker level
Press CENTER LEVEL +/– or REAR LEVEL +/– in Step
5 above.
Notes
• Be sure to select "NORMAL SURROUND" or
"ENHANCED SURROUND" before outputting the test
tone.
• The test tone is not output when "MUTING" appears in
the display.
Getting Started
EN
17