Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10.1 Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
• We recommend that you clean the equipment im-
mediately after you use it.
• Open the left cover (Fig. 1/Item 7) and remove
coarse contaminants (sawings, dust) with a hand
broom.
• Wipe the equipment with a clean cloth or blow it
down with compressed air at low pressure.
• Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the plastic
parts in the equipment. Ensure that no water can
get into the interior of the equipment.
10.2 Servicing
There are no parts inside the equipment which
require additional maintenance.
10.2.1 Bearing(s) (Fig. 1/Item 8)
Periodically lubricate the bearings (8) of the guide
rollers with high-grade machine grease, at the latest
however after 25 to 30 hours of operation.
12. Troubleshooting
Warning: In the interests of operational safety, always switch off the saw and remove the mains plug before
carrying out maintenance work.
Fault
Saw blades break
Motor does not function
Vibration
NOTE: The saw vibrates slightly
when the motor is running in normal
operation.
Saw blade swings out
Holders not aligned straight
24 / 40
LEROY MERLIN – Rue Chanzy – Lezennes 59712 LILLE Cedex 9 – France
Possible causes
Tension incorrectly set
Load to great
Incorrect saw blade variety
Workpiece not fed straight
Mains Gable faulty
Motor faulty
Saw incorrectely installed
Unsuitable underlay
The work bench is not screwed down
or is on the motor
The motor is not secured
Holders not aligned
10.2.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician. Im-
portant: The carbon brushes should not be replaced
by anyone but a qualified electrician.
10.3 Storage
Store the equipment and accessories out of chil-
dren's reach in a dark and dry place at above freez-
ing temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.
10.4 Ordering replacement parts
The following information must be provided on all
orders for spare parts:
• Model/type of the equipment
• Article number of the equipment
11. Disposal and recycling
The equipment is supplied in packaging to prevent
it from being damaged in transit. The raw materials
in this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Defec-
tive components must be disposed of as special
waste. Ask your dealer or your local council.
Action
Set the correct tension
Feed the workpiece more slowly
Use the correct saw blades
Avoid exerting pressure from the side
Change faulty parts
Call customer service. Do not attempt
to repair the motor yourself as this
should be carried out by trained
personnel.
Refer to the instructions given earlier in
this manual for information on installing
the saw
The heavier the work bench is,the
less the vibration. A bench made from
ply wood always vibrates more than
one made from solid wood. Select the
work bench best suited to your working
conditions
Tighten the locking lever
Securely screw the motor in place
Losen the screws with which the
holders are fastenedto the arm.
Align the holders so that they are
perpendicular to each other and
retighten the screws.
24 / 40
Publicité
Chapitres
Table des Matières
