Side Broom Replacement - Nilfisk SW5500 Instructions D'utilisation

SIDE BROOM REPLACEMENT

WARNING!
It is advisable to wear protective gloves when
replacing the side broom because there can be
sharp debris between the bristles.
1. Drive the machine on a level ground and engage the
parking brake.
2. Turn the ignition key (51) to "0".
3. Remove the pin clip (A, Fig. 15), then remove the pin.
4. Remove the broom (B) and recover the protection flange
(C).
5. Install on the hub (D) the new side broom with the
protection flange.
6. Insert the fastening pin and engage its safety clip.
7. Check and adjust the side broom height as shown in the
previous paragraph.
03/2016
INSTRUCTIONS FOR USE
D
C
B
1466465000 - SW5500, FLOORTEC R 985
ENGLISH
Figure 15
A
P100909
27