Use; Battery Check/Setting On A New Machine; Before Machine Start-Up; Checklist - Nilfisk SW5500 Instructions D'utilisation

ENGLISH

USE

WARNING!
On some points of the machine there are some adhesive plates indicating:
DANGER
–
WARNING
–
CAUTION
–
CONSULTATION
–
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates (see the Visible Symbols
On The Machine paragraph).
Do not cover these plates for any reason and immediately replace them if they are damaged.
If the machine has not been used after being transported, check that all the blocks have been removed.

BATTERY CHECK/SETTING ON A NEW MACHINE

WARNING!
The electric components of the machine can be seriously damaged if the batteries are either improperly installed
or connected. The batteries must be installed by qualified personnel only.
According to the type of batteries (WET or GEL-AGM), set the electronic board of the machine.
Check the batteries for damage before installation.
Disconnect the battery connector and the battery charger plug.
Handle the batteries with great care.
Install the battery terminal protection caps supplied with the machine.
The machine requires one 24 V battery, or four 6 V batteries connected according to the diagram (44).
The machine can be supplied in one of the following configurations:
p) Batteries already installed and ready to be used
q) Without batteries
According to machine configuration, proceed as follows.
a) WET or GEL-AGM batteries already installed on the machine
1. Open the hood (19) and fasten it with the support rod (47).
2. Check that the batteries are connected to the machine with the connector (45).
3. Remove the support rod (47) and close the hood (19).
4. On first use of the machine with new batteries, perform a complete charging cycle of the batteries (see procedure in the
Maintenance chapter).
b) Without batteries
1. Buy appropriate batteries (see Technical Data paragraph). For battery choice and installation, apply to qualified battery
Retailers.
2. Depending on the type of battery chosen, set the machine as specified in the Operating Parameters paragraph in the
Maintenance chapter.
3. Perform a complete charging cycle of the batteries (see procedure in the Maintenance chapter).

BEFORE MACHINE START-UP

Checklist

1. Have a full knowledge of the machine operating controls and their functions.
2. Insert the key (51) and start the machine (see the procedure in the following paragraph).
3. In the first 2 seconds after turning on, the multifunction display (71) shows the machine working hours (71-A), the type of
batteries set (71-B) and the current maximum machine speed setting (71-C).
NOTE
Check the battery charge. When at least one non-flashing segment of the battery symbol
display (71-D) is lit, the machine is ready for use. When only one battery symbol segment remains and starts flashing
, it is advisable to recharge the batteries (see procedure in the Maintenance chapter).
14
INSTRUCTIONS FOR USE
SW5500, FLOORTEC R 985 - 1466465000
on the multifunction
03/2016