Installing The Camcorder To The Marine Pack - Sony MPK-DVF6 Mode D'emploi

Preparations (continued)

Installing the camcorder to the marine pack

For DCR-HC40/HC40E/HC30/HC30E/HC20/HC20E/HC18E/HC16E
1
Install the camcorder to the marine pack.
Connect the remote plug and the
microphone plug.
1 Connect the microphone plug to the
2 Connect the remote plug to the
2
Insert the camcorder until the
mounting shoe clicks into place.
3
Connect the monitor cord to the A/V
conversion cable attached to the
camcorder.
4
Attach the front shell to the rear shell.
Hold both shells firmly and fasten the 3
latches securely.
Take care not to pinch the remote,
microphone, and monitor cords. If this
happens water may leak in.
For details on handling the O-ring, see page
29.
Take care not to pinch the cords.
14
-GB
MIC jack (plug in power).
LANC jack.
The cords are placed in the
plug holders of the marine
pack at the factory. Pull the
plugs out of the holders
when in use.
front shell
1 to the MIC jack
2 to the LANC jack
(plug in power)