Olsberg Libera plus 43/118 Mode D'emploi page 26

•
P Press the button 2 times.
The message SET STOVE appears on the dis-
play.
•
Press the ON button to enter the menu.
•
Press ON to arrive at the settings.
The current setting for the day of the week will
flash.
•
Use or to change the day of the week.
•
Press ON to confirm and to jump to the next pa-
rameter.
To exit the menu:
•
Press the OFF button to exit the TIME menu.
•
Press the OFF button to exit the SET STOVE
menu.
10.4.2 DATE
Setting the current date
•
Press the two arrow buttons
same time.
The message MENÜ SET WORK appears on the
display.
•
Press the button 2 times.
The message SET STOVE appears on the dis-
play.
•
Press the ON button to get into the menu.
•
Select DATUM (DATE) by pressing
or .
•
Press ON to get to the settings.
The current setting for the date will flash.
•
Use or to change the date.
•
Press ON to confirm and to jump to the next pa-
rameter.
To exit the menu:
•
Press the OFF button to exit the DATE menu.
•
Press the OFF button to exit the SET STOVE
menu.
10.4.3 LANGUAGE
Setting the desired operating language.
Choices: German, English, French, Spanish and
Italian.
•
Press the two arrow buttons
same time.
The message MENÜ SET WORK appears on the
display.
•
Press the button 2 times.
The message SET STOVE appears on the dis-
play.
•
Press the ON button to get into the menu.
•
Select Language by pressing
or .
+ at the
+ at the
- 24 -
•
Press ON to get to the settings.
The current language setting will flash.
•
Use or to change the language.
•
Press ON to confirm.
To exit the menu:
•
Press the OFF button to exit the menu.
•
Press the OFF button to exit the SET STOVE
menu.
10.4.4 MENU TYPE
The manner in which the operating parameters P, V,
T are displayed can be selected here. Display mode
Rolling or Short can be selected.
Rolling:
The setting parameters appear one after the other in
the display.
In addition, the current measured room temperature
appears, and when the desired room temperature is
reached or exceeded, the following message ap-
pears:
THERMOSTAT ON
Short:
All setting parameters appear at the same time in the
display.
•
Press the two arrow buttons
same time.
The message MENÜ SET WORK appears on the
display.
•
Press the button 2 times.
The message SET STOVE appears on the dis-
play.
•
Press the ON button to enter the menu.
•
Keep the pressed until the message MENU
TYPE appears.
•
Press ON to arrive at the settings.
The current menu type setting will flash.
•
Use or to change the menu type.
•
Press ON to confirm.
To exit the menu:
•
Press the OFF button to exit the MENU TYPE
menu.
•
Press the OFF button to exit the SET STOVE
menu.
10.4.5 STANDBY
Here, you can switch standby mode on or off and set
the desired temperature at which it should switch on
again.
If standby mode is ON, then the unit switches off
when the set room temperature T is reached and
switches on again when the temperature drops below
the set STARTTEMPERATUR.
+ at the