Operator Menus; Timer Menu - Olsberg Libera plus 43/118 Mode D'emploi

10. Operator menus

All necessary settings for the unit are entered via the
operator menu.
Settings can be determined in the following menus:
- SET WORK
- TIMER
- SET STOVE
10.1 Accessing the operator menus
•
Press both of the arrow buttons
neously.
The message MENÜ SET WORK (menu set op-
eration) appears in the display.
•
The button selects between TIMER and SET
STOVE.
•
In order to enter the menu shown in the display,
press the ON button.The paramaters to be set
are selected with ON.If the parameter is blinking,
it can be set by using the
•
To confirm, press the ON button.
To exit the menu:
•
Press the OFF button to exit the menu.
•
Press the OFF button to exit the SET STOVE
menu.
10.2. SET WORK
The following operation parameters are set in this
menu:
P = Heating performance
V = convection ventilator rotation speed
T = Desired room temperature
Example: setting the desired P performance
•
Push both the arrow buttons
ously. The message MENÜ SET WORK ap-
pears on the display.
•
In order to enter into the menu, press the ON
button.
•
Select the paramater P with ON.
•
If the parameter is blinking, it can be set by using
the + + buttons.
•
To confirm, press the ON button.
To exit the menu:
•
Press the OFF button to exit the menu.
•
Press the OFF button to exit the SET STOVE
menu.
+ simulta-
+ buttons.
+ simultane-
- 23 -

10.3 TIMER Menu

This menu is used to set the automatic start up and
shut down times for the unit.
6 programs P1 to P6 can be set day to day.
A desired room temperature of 10 – 30 °C can be
programmed for the selected heating times.
If no room temperature is programmed, the room
temperature listed in SET WORK will be activated.
•
Press both arrow buttons
simultaneously.
The message MENÜ SET WORK appears in the
display.
•
Press the button.The message TIMER ap-
pears in the display.In order to enter into the
menu, press the ON button.
•
By pressing the arrow buttons on the right the
programs P1 to P6 are selected.
•
Press the ON button = the first parameter is
blinking
•
With the or , select ON or OFF, or the de-
sired room temperature between 10 – 30 °C, and
confirm with ON.
•
Select START TIME and STOP TIME with ON,
and set the exact time with the arrow buttons.
•
Select the weekday with ON and, by using the
arrow buttons, activate the programmed switch-
ing times.
A filled-in circle appears in the display next to the
weekday after activation.
To exit the menu:
•
Press the OFF button to exit the menu.
•
Press the OFF button to exit the SET STOVE
menu.
It is possible to select OFF instead of an exact time
for the start up and shutdown times (it comes after
the setting for 00:00 or 23:50). If OFF is entered as
the start up time, the unit does not switch on. If OFF
is entered as a shutdown time, the unit does not
switch off.
This option is useful, if you only wish to enter just
start up or shut down times.
10.4 Menu SET STOVE
In the SET STOVE menu, parameters can be adjust-
ed in the following submenus.
10.4.1 TIME
Setting the day of the week and the current time
•
Press the two arrow buttons
same time.
The message MENÜ SET WORK appears on the
display.
+
+ at the