Timex IRONMAN TRANSIT+ Mode D'emploi page 8

Press and hold button D while timer is stopped to clear all count down time and reload the preset times again.
In Timer mode, press and hold button C to enter the Loop Timer Setting mode. Press button C to select the data
for setting. Press button B or D to change the selected setting digits. The setting sequence is Timer Segment
No, Timer Second, Timer Minute, Timer Hour.
Press and hold button C again to exit the setting mode.
The timer alert beep sound will be generated when each timer counts down to zero. Next segment of the timer
will be loaded and start to count down automatically. The number of loops is 20. Timer will stop automatically.
DAILY ALARM MODE:
Press button C until the mode prompt shows "ALRM". The Alarm-1 prompt "AL-1" will be displayed at the upper
row. The alarm time is displayed at the lower row.
Press button D to select Alarm-1 (AL-1), Alarm-2 (AL-2) and Chime (Hourly chime function).
Press button B to turn the function on / off. If alarm is turned on, "on" will be displayed at the bottom right corner.
If "--" is displayed, the alarm is turned off.
In Alarm mode, press and hold button C to enter the Alarm Time Setting mode. Press button C to select the
data for setting. Press button B or D to change the selected setting digits.
Press and hold button C again to exit the setting mode.
Press any button while alarm sound is active to turn off the sound alert.
INDIGLO® night-light:
The watch provides INDIGLO® backlight for reading the display in dark environments. Press button A in any
mode to turn on the backlight. It lights up the display for 3 seconds.
7