Low Battery - Gallagher M5800i Mode D'emploi

Gallagher 3E3446 M5800i/M10000i Energizer User Manual
Fence Zone 1 - 6
View the Fence Zone performances by pressing the navigation buttons (< or >) until
the zone indication arrow is highlighting the desired fence zone (1 - 6). The fence
zones voltage, current and alarm information is displayed in the same way as the
Energizer output information. See Energizer Output and Alarms section (p.14).
To adjust or turn off the fence zone alarms, see Adjusting/Turning Off Alarms section
(p.15).

Low Battery

When viewing a zone, if the battery icon is displayed, then the zone device needs a
battery replacement.
Adjusting the energizer output voltage
a) Press the setup button (
buttons ( < or >) to highlight the quickscan bargraph display (it will start
flashing).
b) Press (+ or -) to adjust the output voltage up or down. The output voltage can
be adjusted from 4.5KV to 8KV. The factory default setting is 8KV.
c) To exit the setup mode wait 10 seconds or press the setup button (
Controller showing zone 2 with a low battery
) to enter setup mode and use the navigation
Controller showing the output voltage being adjusted
).
15