Understanding Your Energizer Controller; Status Led - Gallagher M5800i Mode D'emploi

UNDERSTANDING YOUR ENERGIZER CONTROLLER

Current Display
Shows the amount of load on the
energizer / fence zones

Status LED

Provides quick
indication of the
fence status
Zone
Indicators
Displays which
energizer / earth
/ fence zones are
operating and if
they are in alarm
Settings buttons
Change alarm levels and
energizer output voltage
Status LED
Green
Red
Flashing Red
Quickscan Bargraph
The Quickscan bargraph gives quick visual indication of the energizer output voltage.
Each bar illuminated represents approximately 1KV output.
Green Segments
Yellow Segments
Red Segments
10
Gallagher 3E3446 M5800i/M10000i Energizer User Manual
Voltage Display
Shows energizer / earth / fence zones voltage
Standby button
Turns the energizer pulses
on and off
The energizer and fence are operating normally
The energizer has detected a fault. Check the LCD screen to
determine where the problem is.
The energizer output voltage is low.
Your fence is performing well. No attention is required.
Your fence is under some load but is still delivering an
effective shock.
Your fence is under heavy load and requires maintenance.
Quickscan
Bargraph
Gives fast visual
indication of fence
voltage
Zone Indication
Arrow
Highlights which
energizer / earth /
fence zone is being
shown on the main
display
Navigation Buttons
View energizer / earth /
fence zones to see zone
performance