Temperature Setting; Timer Setting; Protective Devices For The Appliance; Overheating Protection - SilverCrest STHL 2000 A1 Instructions D'utilisation Et Consignes De Sécurité

6.6 Temperature setting

Press the temperature key 8 to enter
temperature setting mode.
Press the plus key 9 repeatedly to
increase the temperature you desire.
Press the minus key
reduce the temperature you desire. You
can select a temperature between 15
and 40 ºC.
After setting the desired temperature, wait
3 seconds. The specification is assumed
automatically.
If the temperature has been successfully set, the
temperature key icon 2 is lit.
The integrated thermostat now automatically
switches the heating function on/off.
ATTENTION! When setting the temperature, it must
be observed that the appliance does not heat if the
desired temperature is lower than room temperature
or equivalent to it. To heat, the temperature set must
be at least 1 ºC higher than room temperature. This
is displayed automatically when you switch the
remote controller on.

6.7 Timer setting

The timer is used to switch the tower heater
blower off automatically. A switching off
time can be selected in hour steps with
the timer. The tower heater blower then
switches off automatically.
In fan or heating mode, press the timer
key to set the timer.
11
Press the plus key 9 repeatedly or the minus
key to set the switching off time you desire
10
After setting the switching off time, wait
3 seconds. The specification is assumed
automatically.
The timer can be set to an hourly step:
repeatedly to
10
If you wish to ensure that the timer specification has
been accepted, press the timer key
specification is shown on the display.
NOTE: If you set the on/off switch 6 to "O"
position or if the tower heater blower is disconnected
from the electricity supply, the timer and temperature
you have programmed are deleted.

7. Protective devices for the appliance

7.1 Overheating protection

This appliance is equipped with overheating protection.
If the appliance becomes too hot, the heating element
is automatically switched off. To switch the appliance
off, set the on/off switch 6 to "O" and unplug the
mains plug from the mains socket. Let the appliance
cool down for at least 10 minutes.
ATTENTION!
for overheating! It can mean fire danger!
Check whether the appliance can give off its heat
sufficiently: Is the appliance covered or is it too close
to an obstacle? If possible, rectify the problem. Even
if you cannot find a cause, but overheating protection
is triggered again, you must switch the appliance
off and revert to the service hotline (see chapter
"Service").

7.2 Tip-over protection

This appliance is equipped with overturning
protection. If the appliance is accidentally knocked
over or subjected to significant inclination during
operation, it is automatically switched off. The
appliance works exclusively in an upright position.
If timer setting has been successful, the timer key
icon 3 is lit.
There's normally
once. Your
11
a reason
GB/IE/NI/MT/CY 17