Before Commissioning (Tower Fan Heater Without Remote Control); Setting Up The Appliance; Commissioning (Tower Fan Heater Without Remote Control); Standby Mode - SilverCrest STHL 2000 A1 Instructions D'utilisation Et Consignes De Sécurité

3. Before commissioning (Tower fan
heater without remote control)
Remove all packaging material and transport
safety devices from the appliance. Check
whether the packing contents are complete and
undamaged.

3.1 Setting up the appliance

For safe, fault-free operation of the appliance,
its location must meet the following prerequi-
sites:
The base must be firm, flat and level.
Minimum clearance from the casing of 90 cm
at the side, 90 cm at the top, 90 cm at the back
and 1 m at the front must be adhered to.
Do not place the appliance in a hot, wet or very
wet surroundings or in the vicinity of combus-
tible material.
The mains socket must be easily accessible,
enabling easy removal of the supply cable if
necessary.
Temperature range: 0 to +40 ºC
Humidity (no condensation): 5–75 %
4. Commissioning (Tower fan heater
without remote control)
Note: For initial use or if not used for a longer
period, slight odours may arise in the short-term.

4.1 Standby mode

Connect the Tower heater blower to an earthed,
secured wall mains socket. To supply the appli-
ance with electricity, put the on/off switch 6
to position "I". The appliance is then in standby
mode and the display 1 shows the room tem-
perature.
14 GB/IE/NI/MT/CY

4.2 Fan mode

Press the on/off key 5 once in standby mode.
The appliance is then in fan mode.

4.3 Heating level setting (heating mode)

Press the on/off key 5 once in fan mode. The
appliance is then in heating level 1. The tower
heater blower has a heat output of 1200 W.
The on/off key 5 is lit in blue.
Press the on/off key 5 again to change the
appliance to heating level 2. The tower heater
blower has a heat output of 2000 W. The on/
off key 5 is lit in red.

4.4 Switching the appliance off

If the appliance is in heating level 2, press
the on/off key 5 . The fan runs for a fur-
ther 60 seconds before going off (a count-
down is shown on the display). The appli-
ance returns to standby mode. The display
shows the room temperature.
Press 1x: Fan mode
Press 2x: Heating level 1 (1200 W)
Press 3x: Heating level 2 (2000 W)
Press 4x: Switch off (standby)
To disconnect the tower heater blower from the
electricity, put the on/off switch 6 to position
"O".