Start-Up Of The Device/Introduction - AEG MRC 4143 Mode D'emploi

Rear (not shown)
Mains supply cable
Dipole antenna

Start-up of the device/Introduction

• Choose a suitable location for the device. Suitable would be a dry, level, non-slip
surface.
• Sensitive surfaces such as the display are possibly protected with foil. Remove these
foils.
Power supply
• Pay attention to the mains voltage! The type plate lists the correct voltage for your
device.
• Insert the plug into a properly installed power socket.
• If the device is not used for a longer period of time, the mains plug must be pulled
from the power socket.
Inserting the power reserve battery
(not supplied)
If there is a power cut or the mains plug has been removed from the power socket, the
settings will be retained if the power reserve batteries are inserted.
1. Open the battery compartment on the underside.
2. Connect a 9 V, E compound battery to the supply connection. Please ensure the cor-
rect polarity.
3. Close the battery compartment again.
CAUTION:
• Do not expose the batteries to high temperatures or direct sunlight. Never throw
batteries into the fire. There is a danger of explosion!
• Batteries may leak and lose battery acid. If the device is out of use for long periods,
remove the battery.
• Non-rechargeable batteries may not be charged.
• Chargeable batteries may only be charged under adult supervision.
• Chargeable batteries must be removed from the toy before they are charged.
• Batteries must be inserted with the correct polarity.
• Spent batteries must be removed from the toy.
English
45