GE WNRD2050 Manuel D'utilisation page 11

WATER (cont.)
Washer did not fill to
chosen level
(START/PAUSE lights
are flashing)
Water fills and drains
at the same time
SOUNDS
"Metallic clicking"
Back and forth "swoosh"
or light "clicking" sound
during agitate
Quick short agitation
sounds at end of agitate
"Click" when water stops
filling
Motor "whining up" or
"coasting down" in spin
"Humming"
"Gurgling"
Banging noises
Possible Causes
Extremely low water pressure
Inlet hoses are kinked
Water valve screens are
stopped up
Drain stand pipe is too low
Possible Causes
Shifter mechanism is engaging or • The drive system will engage at the start of agitate and
disengaging
Electric motor reversing direction • This machine has a drive system that doesn't use gears.
Clothing redistribution
Relay switch
Motor ramping up/down during
spin cycle
Water drain pump
Water drain pump
Washer is uneven
Washer load is
unbalanced
Shipping rod is still assembled
in unit
Washer is sitting too close to wall • Pull washer away from the wall; about 4" (11 cm)
(causes knocking during cycle)
What To Do
• Press the START button again.
• Straighten hoses.
• Turn off the water source and remove the water connection
hoses from the upper back of the washer. Use a brush or
toothpick to clean the screens in the machine. Reconnect
the hoses and turn the water back on.
• Drain stand pipe must be above 30".
What To Do
disengage when agitate is complete. This occurs multiple
times during the wash.
This sound is the motor rotating back and forth to
agitate your laundry.
• At the end of agitate, the motor makes short agitation
strokes to redistribute the load.
• The relay makes a click sound when activated. The water
level activates the relay and stops filling.
• The motor will speed up incrementally during the spin
cycle. When spin is complete, it will coast until it stops.
• The drain pump will make a humming sound when
pumping out water after agitation stops and continue
until spin is complete.
• When the pump starts drawing in air, it starts to gurgle. The
washer should then begin spinning and the sound will
continue until it is done spinning.
• To level the front of the washer, adjust the front leveling
legs by rotating the individual leg in the proper direction
for up or down. To level back of washer, lift back of
machine 4" (11 cm) and set down.
• Press PAUSE to stop the washer, open the lid and
redistribute the load evenly. Close the lid and press START.
• To remove shipping rod from washer, pull yellow tag and
attached rod from the bottom right hand side of washer.
is needed.
11