Symbol Identification - Dentsply Sirona Nupro Freedom Mode D'emploi

16. Symbol Identification

The following standard symbols appear on the device label.
Class II Equipment
Class II
Equipment
Type B applied part
MEDICAL EQUIPMENT
WITH RESPECT TO ELECTRIC SHOCK, FIRE AND MECHANICAL HAZARDS ONLY IN
ACCORDANCE WITH UL 60601-1CAN/CSA-C22.2 No. 601.1, ANSI/AAMI ES60601-1 (2005, 3rd ed.),
CAN/CSA-C22.2 No. 60601-1 (2008),13VA
Consult instructions for use
Consult
Instructions
for Use
Sterilizable up to the temperature specified
135
Do not re-use (for DPAs)
Do not
re-use
Dispose of in accordance with the Waste Electrical and Electronic Equipment Directive
2002/96/EC of the European Parliament and the Council of the European Union
IPX0
Protection Class IPX0
IPX0 Classification of ingress of water for Charger – not protected
IPX1
Footswitch not for operating theatres
Protection Class IPX1
IPX1 Classification of ingress of water
IPX3
Protection Class IPX3
IPX3 Classification of ingress of water for Inner Module - Protected against falling spray.
Duty Cycle for handpiece:
5 min
5 minutes ON
25 minutes OFF
25 min
Serial Number
Batch Code/Lot Number
LOT
This symbol is a mandatory marking for devices entering the European market to indicate
conformity with the essential health and safety requirements set out in European Directives. The
symbol may be accompanied by a four-digit identification number of the notified body.
Direct Current (DC) supply. 5 Volts, 1 Amp
5V-1A
Do Not Autoclave (Inner Module)
Interference may occur in the vicinity of equipment marked with the following symbol
ENGLISH • 17