Before Initial Use; Inserting / Changing Batteries In The Remote Control; Preparing The Device For Use - Vitalmaxx Wayflex Mode D'emploi

Before Initial Use

1. Remove any possible fi lms, stickers or transport protection from the device. Never
remove the rating plate or any possible warnings.
2. Insert batteries into the remote control (see "Inserting / Changing Batteries in the
Remote Control").

Inserting / Changing Batteries in the Remote Control

Before inserting the batteries, check whether the contacts in the remote control and on
the batteries are clean, and clean them if necessary.
3. Replace the battery compartment cover and fl ip it shut. You must hear and feel it
engage.
Replace the batteries when the performance of the remote control starts to wane.

Preparing the Device for Use

PLEASE NOTE!
■ Only connect the device to a plug socket that is properly installed and matches the
technical data of the device. The plug socket must also be readily accessible after
connection so that the connection to the mains can quickly be isolated.
■ Lay the connection in such a way that it does not become squashed or bent and does
not come into contact with hot surfaces.
1. Place the device on a dry, even and fi rm surface. If the device is used on a carpet,
make sure that the ventilation openings on the bottom of the device remain clear.
Protect sensitive fl oor coverings on which the device is placed with a mat if
necessary.
07125_de-en-fr-nl_A5_V4.indb 19 07125_de-en-fr-nl_A5_V4.indb 19
19
1. Open the battery compartment on the back of the remote
control: Press the catch toward the battery compartment
cover and remove the cover.
2. Remove any used batteries and insert two new batteries
(1.5 V, AAA) into the battery compartment. Pay attention to
the correct polarity (+ / –).
EN
07.11.2019 12:53:45 07.11.2019 12:53:45