Cable Installation; Ec Declaration Of Conformity - Milwaukee M18 FSSM Notice Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 36

CABLE INSTALLATION

For cable installation see picture section.
WARNING! Cable is under pressure and can recoil unexpectedly
during installation, which may result in personal injury. To reduce
the risk of injury, wear safety goggles or glasses with side shields.
Always wear leather gloves.
Read operator's manual. Use protective equipment.
Chemicals, bacteria and other substances that may cause bums, be
toxic or infectious may be present.
Use hot, soapy water to wash hands after handling.
MAINTENANCE
Remove the battery pack before starting any work on the
appliance.
Wash and wipe the exposed cable with a rag. Push the exposed
cable back into the drum.
Before storing the drain cleaner, remove the full length of the
cable. Coil it loosely and clean.
Use only Milwaukee accessories and Milwaukee spare parts. Should
components need to be replaced which have not been described,
please contact one of our Milwaukee service agents (see our list of
guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please
state the Article No. as well as the machine type printed on
the label and order the drawing at your local service agents or
directly at: Techtronic Industries GmbH, Max-Eyth-Straße 10,
71364 Winnenden, Germany.
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that the product described
under "Technical Data" fulfills all the relevant provisions of the
directives:
2011/65/EU (RoHS)
2006/42/EC
2014/30/EU
2014/53/EU
and the following harmonized standards have been used.
EN 62841-1:2015
EN 62841-3-14:2017
EN 55014-1:2017
EN 55014-2:2015
EN 62479:2010
EN 300 328 V2.1.1
EN 301 489-1 V2.1.1
EN 301 489-17 V3.1.1
EN IEC 63000:2018
Winnenden, 2019-11-14
Alexander Krug / Managing Director
Authorized to compile the technical file
Techtronic Industries GmbH
Max-Eyth-Straße 10, 71364 Winnenden, Germany
English
28
28
SYMBOLS
CAUTION! WARNING! DANGER!
Please read the instructions carefully before starting the
machine.
Always wear goggles when using the machine.
Wear gloves! Leather gloves recommended!
Remove the battery pack before starting any work on the
appliance.
Accessory - Not included in standard equipment, available
as an accessory.
Do not overstress cables.
Overstressing cables may cause twisting, kinking, or
breaking of the cable and may result in serious injury.
Auto feed / retract selection on
Auto feed / retract selection off
O
Clockwise spin (forward)
O
Counter clockwise spin (reverse)
Do not dispose electric tools, batteries/rechargeable
batteries together with household waste material.
Electric tools and batteries that have reached the end of
their life must be collected separately and returned to an
environmentally compatible recycling facility. Check with
your local authority or retailer for recycling advice and
collection point.
This device contains a button-type/coin cell lithium
battery.
n
No-load speed
0
V
Voltage
Direct Current
European Conformity Mark
Ukraine Conformity Mark
EurAsian Conformity Mark

Publicité

Table des Matières
loading

Table des Matières