Ordering Spare Parts - ESAB Warrior Feed 304 Manuel D'instructions

US
Welding torch
S
Cleaning and replacement of the welding torch wear parts should take place at
regular intervals in order to achieve trouble-free wire feed. Blow the wire guide
clean regularly and clean the contact tip.
10

ORDERING SPARE PARTS

Repair and electrical work should be performed by an authorized ESAB service
personnel. Use only ESAB original replacement and wear parts.
The Warrior Feed 304/Warrior Feed 304w is designed and tested in accordance with
International standards IEC 60974-5, Canadian standards CAN/CSA-E60974-5 and US
standards ANSI/IEC 60974-5.
On completion of service or repair work, it is the responsibility of the person(s) performing
the work to ensure that the product still complies with the requirements of the above
standards.
When ordering replacement parts, order by part number and part name, as
illustrated on the figure. Always provide the series or serial number on the unit on
which the parts will be used. The serial number is stamped on the rating plate.
bm55d1a
- 20 -
© ESAB AB 2013